The Annoying Lego Machine
To make this machine, you will need
- Legos for the arm
- enough technic legos (the ones with holes through them) for the "arm"(obviously)
- 1x4 lego plate (the flat ones, 4 of those)
- 12x1 technic brick (3 of those)
- 8x1 brick (2 of those, holes optional)
- 6x1 technic brick
- 4x1 technic brick
- 2 blue bush pins (longer than regular pegs)
 |
| all arm pieces |
 |
| assembled. (sorry the picture is upside down...) |
- Legos for mechanism #1
- one 5.5 axle with stopper
- one lego rim (not the tires, but the insides of them!)
- One bush (these are the little circles with a cross inside that go on the axles to make sure things don't move around.)
- one small gear
 |
| all mechanism #1 pieces |
 |
| mechanism #1 assembled |
- Legos for mechanism #2 and stabilizer
- one ten stud long axle
- One bush
- one half-bush
- one lego rim
- two bush pins
- 1x9 liftarm
- 1x5 liftarm
- one axle pin
- 1x2 technic liftarm
 |
| all mechanism #2 pieces |
 |
| Mechanism #2 pieces assembled, stabilizer assembled and unconnected. |
- The Annoying part
- arm with both mechanisms attached
- stabilizer
- ball chain (one of those necklaces with tiny metal balls)Mine was 28 inches.
 |
| IMPORTANT: make sure the chain crosses!! |
 |
Note: you might have to put chain on before you connect
mechanism #2 and stabilizer. |
There you go!
If you're not sure what the names refer to, here is the resource I used to identify them: http://brickarchitect.com/labels/
